CAP Arreghini

Product for the surface impregnation of wood, for interiors and exteriors, highly penetrating with a finish that enhances the wood grain. Available in transparent colours obtained from micronized mineral pigments with high resistance to light which give the wooden structures treated an even colour and protection against the deterioration caused by the UV rays and atmospheric agents, elements indispensable for the duration of the applications, and useful for protecting the structure over time.
Its excellent quality guarantees good saturation of the wood pores with minimum swelling of the wood fibre and even and uniform distribution of the colour, so as to create a substrate that guarantees good adhesion of the finishing coats and uniform covering of the film with excellent aesthetic results both in professional and in do-it-yourself applications, as it is easy to apply with both manual or mechanical tools.
Water-dilutable product formulated with alkyd resins in aqueous dispersion and fungicides that guarantee resistance to mould and excellent resistance to UV rays; for maximum protection in exterior environments, in severe conditions of exposure to atmospheric agents and sunlight, the product must be recoated with suitable finishes.
Being odourless, it is particularly suitable for poorly ventilated areas. It is formulated with raw materials selected for their low environmental impact, guaranteeing reduced pollution and minimum emissions, so as to preserve the well-being and safety of its users and of those living in the environment.

PROPERTIES OF THE DRIED FILM

• GOOD RESISTANCE TO MOULD        
• EXCELLENT RESISTANCE TO UV RAYS        
• EXCELLENT EVEN COLOUR            

COLOURS
As per the samples. The range of colours can be extended using Novolegno W Concentrato. Before application, it is always advisable to check the tone with preliminary tests, since the original colour of each type of wood produces a different final shade. The darker shades give better protection from UV rays. The colour could vary slightly from one production batch to the next; it is therefore important to finish the job with the same batch.

USE
As an undercoat on raw surfaces of various types of wood, during the semi-transparent coloured paint cycle with water-dilutable acrylic finish on structures such as doors and windows in general, matchboarding, beams and other wooded structural elements.  It is characterized by good coverage and flowability which facilitate application, especially with flow-coating, impregnator and dipping systems. If the product has been stored at low temperatures, allow it to reach a temperature of at least +15 °C before applying.
During application and drying time, the temperature should be higher than +15°C and the humidity of the air lower than 65%; it is important for the environment to be well-ventilated in order to facilitate water evaporation.
Drying can be done at ambient temperature or with a hot air tunnel (35° to 50°C), in which case brushing may be carried out after 3-5 hours, allowing a reduction in work times.
Clean the tools with water.

TOOLS
Brush, Spray-gun, Dipping, Impregnator, Flow-coating.